3
$\begingroup$

I am looking for the correct formula to convert IRT discrimination parameters obtained from a logit-link model to a correlation metric. Because of the logit scaling factor (1.702), I am a bit unsure as to the correct formula.

In the case of a probit model it is simply $\frac{\alpha}{\sqrt{1 + \alpha^2}}$, where $\alpha$ is the discrimination parameter. But how precisely does this formula change for the logit-link discrimination conversion?

$\endgroup$

1 Answer 1

2
$\begingroup$

I was able to track down the correct formula which is essentially the same as above except 1.00 in the denominator is replaced with 3.29, thus:

for a factor correlation metric (standardized) from a logit-link discrimination parameter

$\frac{\alpha}{\sqrt{3.29 + \alpha^2}}$, where $\alpha$ is the discrimination parameter.

$\endgroup$
9
  • $\begingroup$ Can you please provide a citation? $\endgroup$ Nov 7, 2018 at 0:33
  • $\begingroup$ See slide #6 in this link: lesahoffman.com/PSYC948/948_Lecture6_Binary_Responses.pdf $\endgroup$
    – Jhaltiga68
    Nov 8, 2018 at 11:47
  • $\begingroup$ I know both models are the same. I was asking about the loading to discrimination transformation. See page 144, table 2 of unc.edu/~dbauer/manuscripts/kamata-bauer-2008.pdf. I think the formula for probit always applies as the 1 is about the standardized latent factor variance, not the error variance. $\endgroup$ Nov 8, 2018 at 12:29
  • $\begingroup$ Not sure what your question is Jim. You asked for a citation re: my example of factor loading from discrimination. But you want discrimination from factor loading I see. Your point about the 1 makes intuitive sense, but I don't know for sure without doing due diligence. $\endgroup$
    – Jhaltiga68
    Nov 9, 2018 at 6:15
  • 1
    $\begingroup$ I ran some IRT models using Bayesian software, checked old class notes, looked at the linked paper a little closer (paper focused on probit since binary/ordinal CFA uses tetrachoric corr which is probit-based) and I'm now certain that your original answer was correct (+1 your answer). Only note is $\pi^2/3$ does not work well for the variance of logistic in practice. $1.7^2$ works better according to a number of papers in the psychometric literature researchgate.net/publication/… $\endgroup$ Nov 10, 2018 at 5:30

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.